A DIY Guide to Common Plumbing Fixes
Have you ever experienced a plumbing issue in your home, only to find out that fixing it is going to cost an arm and a leg? Or worse, you have to wait for days on end for the plumber to show up?
Don’t worry!
This guide is here to help you with your plumbing woes.
In the points below, we will provide step-by-step instructions on how to fix common plumbing issues, such as blocked drainage Brisbane, without breaking the bank.
Let's get started!
Blockages in Drains
One of the most common plumbing problems is blockages in drains. Blockages are usually caused by debris or objects that have been washed down the sink or flushed down the toilet.
To unclog your drain, you'll need a plunger and some elbow grease. Start by plunging vigorously and making sure that you cover any openings so that all of the air pressure is concentrated in one area. Then, try using a mixture of vinegar and baking soda (1 cup of each) and hot water (2 litres).
Pour the mixture into the blocked drain and let it sit for at least 15 minutes before attempting to plunge again. If plunging doesn’t work, then you may need to use a chemical drain cleaner or snake your pipes.
Leaks in Pipes
Leaks can be caused by several different factors including corrosion, damaged seals around joints, or even misalignment of pipes due to ground movement or settlement. If you notice any water around your pipes, then it’s important that you take action quickly - leaking pipes can cause further damage if left unchecked.
The first thing to do is turn off the water supply so that no more water escapes from the leaky pipe. Once this is done, you can start assessing what needs doing - if it's just a small leak, then replacing washers or tightening fittings should fix it. However, if there is more extensive damage then replacing sections of pipe might be necessary. It’s important not to attempt any DIY pipe repairs unless you are confident in your own abilities, as mistakes can lead to major complications later on down the line!.
Replacing Faucets & Sinks
Another common plumbing project is replacing an old faucet or sink with a new one. This can be a daunting task for someone who has never done it before, but it's actually quite straightforward once you understand the steps involved.
Start by turning off the water supply, then use adjustable pliers to unscrew any nuts or bolts holding on your old fixture. Next, disconnect any pipes connected to your old fixture by loosening them with an adjustable wrench (if necessary).
Install your new fixture following the instructions included in its packaging, then use pipe sealant tape or putty on all connections before re-tightening them with adjustable pliers or wrenches (as applicable). Finally, reconnect your water supply lines and turn on the water supply - you’re done!
We hope this guide has given you an insight into how to tackle some of your potential plumbing problems without breaking the bank
With some basic knowledge about how drains and pipes work, DIY plumbing fixes become much simpler - allowing us all to save money while getting our homes in order! Remember though: always stay safe when tackling any kind of repair job. If you aren't sure what’s wrong with something, then don't hesitate to call out an expert who will be able to identify whatever problem may exist and offer tailored advice on how best to go about fixing it. Good luck!
